Steel anchors Fischer FAZ II, ZYKON FZA, FH II, etc.

The FAZ II anchor bolt is suitable for pre- and through -mounting; under certain conditions it is suitable for remote mounting.

The FAZ II GS anchor bolt is suitable for pre- and through -mounting; under certain conditions it is suitable for remote mounting.

The FH II anchor bolt is suitable for end-to-end mounting. During tightening, the cone moves into the spacer sleeve and expands it, pressing it against the walls of the drilled hole.

• Anchor bolt FH II. Technical description.

The ZYKON FZA undercut anchor is suitable for pre-installation, and the anchor FZA-D – for end-to-end mounting. The hole with a conical undercut is drilled with a special FZUB drill.

The anchor with ZYKON FZA-I trimming and with internal thread is suitable for pre -installation. The hole with a conical undercut is drilled with a special FZUB drill.

The ZYKON FZEA II scoring anchor is suitable for pre-installation. The hole with a conical undercut is drilled with a special FZUB drill.

The screw on concrete FBS is suitable for end-to-end installation. When screwing the screw into the drilled hole, the edges of the thread profile cut into the concrete.

• Screws on concrete FBS. Technical description.

The EA II scoring anchor is suitable for pre-installation. Insert the driving anchor into the drilled hole and hammer it flush with the surface of the building base.

Nail anchor FNA II. The installed anchor is automatically fixed under the action of the load, while the cone moves into the spacer sleeve and bursts it in the walls of the drilled hole.

The ceiling anchor wedge FDN is used for end-to-end mounting with group mounting. The anchor is hammered into the drilled hole with a hammer until it is fully fixed.

The FBN II anchor bolt is an economical attachment for a wide range of applications in unstretched concrete. Suitable for pre- and end-to-end installation. It is suitable for remote installation under certain conditions. Before installation , a hex nut must be installed.

The FBN II GS anchor bolt is an economical attachment with an enlarged washer for a wide range of applications in unstretched concrete. Suitable for pre- and end-to-end installation. It is suitable for remote installation under certain conditions.

EXA anchor bolt. Easy-to-install mounting for unstretched concrete. Suitable for pre- and end-to-end installation.

Anchor for high loads TA M. Easy-to-install anchor with internal thread for mounting in unstretched concrete. During tightening, the cone moves into the spacer sleeve and expands it, pressing it against the walls of the drilled hole.

Anchor for high loads TA M-T. Easy-to-install anchor with internal thread for end-to-end installation in unstretched concrete. During tightening, the cone moves into the spacer sleeve and expands it, pressing it against the walls of the drilled hole.

The FSA bushing anchor is used for end-to-end mounting when fixing building structures in unstretched concrete. During tightening, the cone moves into the spacer sleeve and expands it, pressing it against the walls of the drilled hole.

Reusable mounting system for FDBB diamond drilling rigs. Installation of the kit is carried out by driving the bolt into the drilled hole with a hammer through the base plate of the diamond drilling installation.

Wall screw MR. It is used for simple impact mounting in unstretched concrete. Suitable for pre- and end-to-end installation. The anchor sleeve is hammered into the drilled hole with a hammer without a spacer pin.

Anchor for hollow floors FHY. Easy-to-install anchor with internal thread for mounting in prestressed hollow slabs. Suitable for pre-installation. For proper expansion, the anchor must rest on the attached part during installation.

Catalog

Brochure